I have 2 7000 series MultiCam machines and they are both not cutting square. has anyone else had issues like this? I convinced my company to get these machines now I'm looking like a fool.
I have 2 7000 series MultiCam machines and they are both not cutting square. has anyone else had issues like this? I convinced my company to get these machines now I'm looking like a fool.
Call Multicam.
Did you buy them new?
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
I assume these machines are new and that this is a new installation. Were they adjusted when commissioned? Have they ever been square? The machine documentation should have instructions on adjusting.
Jim Dawson
Sandy, Oregon, USA
these are new machines we haven't done a lot of work in the 8 months we've had them that squareness was an issue. But we've taken on some jobs recently that requires some jigs for our metal fab guys and that's when we found out how bad it was. the tech is here today, and getting them right. Just was curious if this was an issue with MultiCam.
It's an issue with any new machine installation, they need to be leveled and aligned when installed. That's part of the commissioning process for all new equipment, the machine manufacturer makes no difference.
Jim Dawson
Sandy, Oregon, USA