Retrofitting a D&M lathe with a AcornCNC motion controller and am a little weary of how to hook up the DC drive to the motion. However I could just be making a mountain out of a mole hill in my head. Here's what I know:
*The motion controller supplies a 0-10 vdc signal to the spindle drive
*The DC drive uses a 10 volt reference signal and an external 10K POT to control spindle speed
Is it as simple as connecting the motion controllers 10 volt signal to terminals 2&3? (see the attached photos)
Any insight into this would be greatly appreciated!
Thanks,
Joey