Good evening all,
I have the need to get that little bit more travel out of my Y axis. I have an 1100s3 running PathPilot 2.2.4.
In doing research on how to, I found this thread from 2015 - https://www.cnczone.com/forums/torma...ft-limits.html
However, when attempting to make the change ADMIN SET_Y_LIMIT x.x, I get the nanny interfering - "Soft limit is out of range for axis, capping at -9.5000000"

Is there a way to dig in and adjust the capping range? I need 10" and it's there by just moving the rear Y limit block alone but I need PP to cooperate.