Hi,
I have a Stama MC010 with Fanuc OM controller form 1990. As far as I know the machine is equal to Fanuc Dill Tap T. My machine entered into a state where I can't edit programs and offsets as if my Program Protect key was turn ON.
I already verified and my Program Protect Key switch is working properly (is has continuity on the two wires when I turn to OFF and no continuity when turned ON). I also confirmed the the the Diagnosis parameter 0122.3 is commuting to 1 when the Program Protect key is OFF.
Additional, some days ago I run a program several times and I went in to PS 097 Alarm before making a tool change. I could only clean this error by switching the machine OFF and ON again and after that the machine was normal. I think this one is just a tool change procedure mistake and these two problemas are not related. But how knows...
Does know someone know how can I solve this or how can I proceed with the diagnostic?
Thanks in advance.