Hello Forum,
I'm the new guy, I have a Vectrax mill with centroid controls MSC M-15 CPU7
today I powered up and I got the 411 error
I got 120VDC on terminal 9 and 10
I checked all the fuses and they are okay.
All the red LED's for the axis go out when I try to jog each axis.
only the fault lED is lit
any ideas?
your help is appreciated.
Results 1 to 2 of 2
-
09-27-2019, 08:19 PM #1
Member
- Join Date
- Sep 2019
- Posts
- 1
Motion error 411 axis full power without motion
-
09-28-2019, 08:05 PM #2
Registered
- Join Date
- Feb 2008
- Posts
- 280
Re: Motion error 411 axis full power without motion
If the green UV and USV LEDs are out, even though you have 120VDC going into the VM+ and VM- ("GND") terminals, then there is a problem on the drive board. Possibly a blown fuse on the drive board, but if that is the case, there is most likely a more serious problem behind it.
If in fact the UV and USV LEDs are lit, then the problem is more likely to be with the limit switch circuit (the 8-position plug mid-way along the front edge of the drive board).
Reply With Quote
Posting Permissions
