Today I tryed to use 4th axis. But i can't use CS command because I recive #18 error for A axis. I wanna mention is a VM65 ... and when I can't turn the chuck by hand.
Best regards,
Today I tryed to use 4th axis. But i can't use CS command because I recive #18 error for A axis. I wanna mention is a VM65 ... and when I can't turn the chuck by hand.
Best regards,
Today I change the cards with X cards, error was the same ... axis A. Also today I disassembled the motor, I cleaned the old oil, check the backlash... everything is great there.
Someone have other suggestion?
Best regards,
Its probably the AMP-0006 unit. There is a fuse on the board you can check.
https://www.fadalcnc.com/index.php/amp-0006.html
Not sure which Model Fadal you have....this is photo of a Model4020. The AMP-0006 is mounted on there
Attachment 428422