[Marty_Escarcega]

I aquired a 2003 TRM. It had been sitting for quite awhile.
It lost its parameter settings.
In haste, I reloaded some defaults so I could jog the Z down to clear a door.

Now, I wanted to correctly reload the parameter settings.
First, is there a way to default the control, clear everything to start again?

The issue is that while I can change axis configuration, (its ok at X, Y, Z) it will not let me in to the field to change the travels, which it defaulted to and are incorrect.
I can't remove references to ATC and # of tools either, cant change the spindle RPM, RPM Factor etc. Won't let me cursor to those settings.

Attached are a couple of screen shots.
I'm out of ideas.

Thanks in advance.
Marty

[rwskinner]

Make sure they key is installed and turned on, or open the pendant and install a jumper across the switch. I'm not certain that's your problem but mine limits what I can change in setp unless the key is ON.

[Marty_Escarcega]

Make sure they key is installed and turned on, or open the pendant and install a jumper across the switch. I'm not certain that's your problem but mine limits what I can change in setp unless the key is ON.

Thanks for the reply. My pendant does not have a key switch. That's not to say there isn't a place in the control cabinet to put the jumper in or slide a switch. That would make sense.