[hindocarina]

I'd like to be able to set Z0 without touching the mouse. This way one hand could hold the feeler strip while the other hand cycles through the jog commands:

1. the tab key would open the jog window.
2. another key would set the jog mode to step.
3. another key would set the cycle jog step increment.

Is there a way to do this?

Thanks,

Charlie

[9lrac9]

Hey... Charlie you answered it your self, Now that you found tab key. set your key board in front of you as I do, and set it on 1.00 or .100 .010 .001 and hit your page down or page up if you went Z- too much, I hit the key with my left hand and I'am l sliding the block at what ever height you want to set the Z at with my right hand. SIMPLE STUFF. Charlie what are you making...


9lrac9

[9lrac9]

Charlie... That's the safe way.


9lrac9

[ger21]

http://www.artsoftcontrols.com/MachC...andard_Hotkeys

[9lrac9]

Just trying to keep it simple. After learning the 30000000000000000000000000...
hot keys in MC9. In Mach 3 I try to not go nuts... Thank you ger21

[9lrac9]

And yes I have downloaded all 154 pages of Mach 3


9lrac9

[hindocarina]

Thanks for the responses.

9Irac9, I'm making wooden ocarinas. Now you know as much as you did before...right? It's a type of musical instrument. If you're curious, you can see some of them on the following page from my website:

http://hindocarina.com/sweet_potato.htm

Charlie