Hi friends! New challenge in my machinist life, this time we bought a Mikron wf 54 vh with TNC 415 and when I try to operate it in Manual or Program Run mode every time when I press the Start Cycle key it gives me an error message "96 blocked function".
any of you could help me with this? :drowning:
I have to mention that i'm using Mikron with ISO G-code programming since 2013 and in all of this time I bumped in lots of issues but always I managed to pass them...until now.

https://youtu.be/PUGFPsddGzs

on the link is the video of its behavior.
all the best! :cheers: