I have a question regarding drilling cycles on my Maxim 630 with an Acramatic 950 CNC.
We have a deep hole we need to peck drill. I wanted to take a large initial peck and then a reduced amount for each additional peck. Is this possible in the cycles or would it need to be written out long hand?
Thanks.
Thread: Acramatic 950 Cycles
Results 1 to 4 of 4
-
10-23-2019, 03:23 PM #1
Member
- Join Date
- Jul 2005
- Posts
- 380
Acramatic 950 Cycles
-
10-23-2019, 06:03 PM #2
Registered
- Join Date
- Mar 2011
- Posts
- 462
Look in your programming manual at G83. Using a K word sets a variable depth per peck. I believe it only has 3 stages though (3xK for first peck, 2xK for 2nd peck and 1xK for all additional.
A J Word can also be used for chip breaking (J0) or chip clearing (J1) in the cycle.
-
10-23-2019, 06:12 PM #3
Member
- Join Date
- Jul 2005
- Posts
- 380
Re: Acramatic 950 Cycles
Thank you!
-
10-23-2019, 07:49 PM #4
Member
- Join Date
- Jul 2005
- Posts
- 380
Re: Acramatic 950 Cycles
You are correct, there are only 3 stages. I found the data. Again, thanks.
Reply With QuoteSimilar Threads
-
can cycles
By GCODE_FAN in forum OkumaReplies: 3Last Post: 11-27-2014, 12:27 PM -
SL cycles
By Spezialagent in forum HEIDENHAIN -> GENERICReplies: 1Last Post: 11-28-2011, 10:10 PM -
cycles
By omnia in forum HEIDENHAIN -> TNCReplies: 1Last Post: 10-08-2011, 12:41 PM -
Own cycles
By opferich in forum SIEMENS -> GENERALReplies: 2Last Post: 12-22-2009, 10:23 PM -
Cycles 251, 252, 253
By master@mzp in forum HEIDENHAIN -> TNCReplies: 2Last Post: 07-30-2008, 05:39 PM
Tags for this Thread
Posting Permissions
