[alivexx1]

Hello, I have an Okuma LU 300 with P200L controls. I need to install the osp system software, but I only have [CD 2]. Could anyone share the files for [CD 3]? That would be a great help! I would like to get my machine up and running tonight for 3rd shift to run some orders.

I am unsure if another persons CD from a machine will work on my machine? If they are the same machine and controls, I would assume so?

Thank you!

[deadlykitten]

hi, cd's are pretty machine specific, especially the osp [ maybe cd2]

cd3 may contain the model data, thus it is <> osp, so maybe you can start your machine only by installing cd2, but so far i never tried this

even if it works, do some testing, especially if the machine is used on 3rd shift

look on the hdd, maybe there is the kit copied on it, from the previous installation; why is needed to re-install the osp ? kindly

[alivexx1]

I found the CD #2 and installed. Our hard-drive is showing internal hard-ware fault, RAM / memory parity error. So either issue is in RAM or hard-drive. I found another hard-drive for same controls (P200), so I had to install osp software and "restore" my parameters and user data file to this. I was able to get my program opened up, but I am still getting the hardware fault, so maybe the issue is in the RAM card. I am working to change out RAM card today.