[figeacaero]

Dear all,

Unsuccesfully, I try to make a backup of the PMC Ladder, on a Mori seiki SH63 machine.
I've an ATA card slot fitted on the Cnc box, but I can not put 4 in the parameter #20 (I/O device). Alarm: data out of range, but I can put 5 in this parameter (hard disk device).
Can somebody help me in this procedure, or other (RS232, but Ive never use it before).

Thanks a lot

[vishal105]

Can give me more detail about machine electric system like which controller used for machine and atc etc.

[memoryman]

The 16A never supported pcmcia cards. The ladder is stored on eproms.

[jdeere4250]

Dear all,

Unsuccesfully, I try to make a backup of the PMC Ladder, on a Mori seiki SH63 machine.
I've an ATA card slot fitted on the Cnc box, but I can not put 4 in the parameter #20 (I/O device). Alarm: data out of range, but I can put 5 in this parameter (hard disk device).
Can somebody help me in this procedure, or other (RS232, but Ive never use it before).

Thanks a lot

You can output the ladder by cable using rs232c.

I often did it, but never had to reload it this way.

[vishal105]

Dear all,

Unsuccesfully, I try to make a backup of the PMC Ladder, on a Mori seiki SH63 machine.
I've an ATA card slot fitted on the Cnc box, but I can not put 4 in the parameter #20 (I/O device). Alarm: data out of range, but I can put 5 in this parameter (hard disk device).
Can somebody help me in this procedure, or other (RS232, but Ive never use it before).

Thanks a lot

I have mori seiki sh-63 ladder file with parameter in pdf.
But atc controller power mate f paraeter and other file lost.
Can you send me a more detail about mori seki sh-63 on this mail id [email protected].
It will really help ful for me.
Thanks in advance.

[bill4807]

Try to use an SRAM card.
And back it up through the boot screen.

[vishal105]

Dear all,

Unsuccesfully, I try to make a backup of the PMC Ladder, on a Mori seiki SH63 machine.
I've an ATA card slot fitted on the Cnc box, but I can not put 4 in the parameter #20 (I/O device). Alarm: data out of range, but I can put 5 in this parameter (hard disk device).
Can somebody help me in this procedure, or other (RS232, but Ive never use it before).

Thanks a lot

Pm me I will teach full process of backup.

[memoryman]

It is NOT an 'ATA' card slot, but a pcmcia slot. ATA refers to the memory type off the pcmcia card. Only the i-series controls could be used for general i/o. The 15B,16/18 B or C could not.

[vishal105]

It is NOT an 'ATA' card slot, but a pcmcia slot. ATA refers to the memory type off the pcmcia card. Only the i-series controls could be used for general i/o. The 15B,16/18 B or C could not.

Please refer this link to take back up from 16M controller
http://www.kfasllc.com/memory_backup_restore_F1618.htm
Mail me on [email protected] I need help for parameter.