[s7ega]

Hello evryone
I have a problem identifying the machine cnc3018 with cable for the laptop .
When I connect the machine cable to the laptop. Windows does not recognize the machine. This message appears
(( look at the picture ))

Windows Message
https://1.top4top.net/p_1402cvzj41.png

Note . that when i run the machine with Offline remot operates without problems ..
The cable also has no problems

please help

Picture of the control board
https://2.top4top.net/p_14026st1s1.png

[Sterob]

Looks like you need to find the USB driver and install it. Nothing in the documentation that mentions that?
A quick google bought up a post mentioning the CH340 driver. Ring a bell?

[BlueDomino]

I had set up a similar 3018 machine not too long ago and that definitely looks like you are missing a CH340 driver, I would recommend checking out Techdiy's video on the 3018 cnc:

https://youtu.be/hB4Cvbtu-lA?t=661

He goes through a concise rundown of all the necessary steps.

[john-100]

After looking at the photo of the board I think the board is based on the Arduino nano

The circuit diagram of the original nano uses the FT232 USB to RS232 converter IC

http://www.ba0sh1.com/wp-content/upl...noNano-3.3.png

FT232 driver

https://www.ftdichip.com/Products/ICs/FT232R.htm



clones of the Arduino found on line use the CH340 which needs its own driver to be installed on the PC

see

https://learn.sparkfun.com/tutorials...40-drivers/all


Have a look at the part number on 16 pin IC near the USB connector to see if they have used
the CH340 or FT232R


John