the part is ~.53" and I'm using a 1.0" bull end mill (r=.0315) but master cam tells me it can't do one pass because its not big enough?
Any clues would be good thanks!
ETA: the file is attached, as well as a picture of the issue
Thread: Why can't I use one pass here?
Results 1 to 3 of 3
-
11-07-2019, 01:07 AM #1
- Join Date
- Sep 2019
- Posts
- 2
Why can't I use one pass here?
-
11-07-2019, 08:07 AM #2
Flies Fast
- Join Date
- Dec 2008
- Posts
- 3109
Re: Why can't I use one pass here?
Turn on "Auto Angle" ... or set "Rough Angle" to 90° or 270° to machine the thinner section
-
11-07-2019, 07:32 PM #3
- Join Date
- Sep 2019
- Posts
- 2
Re: Why can't I use one pass here?
omagosh, thank you. The instructor gave us hard limit on our verify time, and you just saved me 10 seconds, and gave me the finish I want
Reply With QuoteSimilar Threads
-
Bad cut on second pass
By L0UIE in forum Laser Engraving / Cutting Machine General TopicsReplies: 0Last Post: 05-31-2017, 01:11 PM -
To buy or pass?
By A1CNC in forum FadalReplies: 5Last Post: 08-19-2015, 12:45 PM -
Pass Through?
By Jtron5 in forum Laser Engraving / Cutting Machine General TopicsReplies: 15Last Post: 02-09-2011, 09:45 PM -
Step over 2nd/3rd pass
By Sjotime in forum DIY CNC Router Table MachinesReplies: 11Last Post: 12-09-2010, 07:30 AM -
Bad pass
By ozstockman in forum Metalworking- / Woodworking Tooling / Manual MachiningReplies: 12Last Post: 01-04-2010, 08:32 AM
Tags for this Thread
Posting Permissions
