I’m having a problem where my mill will slow down to about 30% of the programmed feed rate on any type of arc 2 axis or 3 axis movement. This really kills the cycle time and it’s not like I’m feeding fast so I don’t think it would be an acceleration or deceleration issue. Ex. I can program for 1 IPM and it will do .3 on an arc. I hope it’s just a parameter change but I’m having a heck of a time trying to find it and the application guys at Hardinge pretty much just blew me off. I would greatly appreciate any input on this. The mill is a 2000 Hardinge VMC 1000II with the Fanuc OMD