Hi guys,
As the title suggest I am very new to CNC, and feel a bit out of depth in attempting to solve this problem.
Any help would be very much appreciated.
I have inherited a CNC milling machine that had a dead spindle motor. Everything else for the cnc was wired up except for the spindle motor, so I'm not sure what and where to connect it to.
Being new to cnc I don't have much experience with cnc machines or electrical systems, I am worried if I wire it incorrectly I will blow something up.
I have attached some photos. The red square is where i think it should be wired in, however the motor only has 3 wires and there are 4 points remaining.
Again, any help is very much appreciated,
thanks in advance,
Christopher