I have a Gerber Sabre 408 router that has a 3 phase Colombo spindle, but my residential shop only has single phase 220v power.
I've hooked up an external single phase to 3 phase VFD and I can control the spindle with it (on, off, RPMs).
But when I try to run a job on the machine it fails with "Spindle I/O Error" because it isn't getting a signal back from the spindle control box, since it isn't hooked to power.
Is there any way to tell the machine it doesn't have a spindle attached or to ignore the error and run anyway?
Thanks