Hello all,

I was hopping someone could help me. I have a shopbot PRT Alpha and I am upgrading to a Acorn_REV4 CNC control boards with 4 gecko g251x drivers using the original Vexta PK299-01AA stepper motors. I would like to use meanwell din power supplies and I was thinking that a separate power supply for each motor would be better, is this true? I did notice that the g251x drives have a minimum req of 15vdc, am I reading that right? If true then I could NOT use "MEANWELL MDR-40-12" these would be to small for the g251x?
If I just went with one din power supply which one would be best?

Thank you for your help in advance.

Regards,
Devin