I have just bought a setup from CNC4PC based on the M16D Pokeys Motion motherboard and I am trying to figure out how to use it to control my LMS 5200 Lathe (https://littlemachineshop.com/produc...3995&category= ) spindle (on/off, fwd/reverse and speed).

I have also bought from LMS their CNC spindle control upgrade kit from LMS https://littlemachineshop.com/produc...ory=1687114045, but not sure if I need it.

Electronics is not my strong suite, so any help on how to wire it up would be gratefully received.

Thanks

David