HI cnc maniac
i bought MB3 controller board and 2 week i fight with wiring and setting. Until now i used LPT desk+ESS+driver 3ND883.
Driver have 6 pin (ENA+-,PUL+-,DIR+-). On the desk is also 6 pin. On Mach4 i make setting PIn XX is enable pin.
If i touch button enable motor make typical sound(turn on).
On MB3 i connect PUL+- to XS+-,DIR+- to XD+-, ENA+ to 5V,ENA- to 0V. i try change 5V to VCC and 0V to GND.
On MB3 is not ENABLE PIN and i don´t have seting in mach4 to enbale?
HOW function enable in MB3? I install all program and MB3 profil. Spindle i connect and if i push spindle button in mach it is work.
relay also work. e stop work but motors no.
Can you help me whit my problem?Definitaly is my mistake but this modern desk is smarter than me.