Hi folks, so I bought a 1515 workbee cnc router, comes with drivers and motors, same time I bought a new driver and motor kit which is a bit over board being nema 34 so I might use them still until I build my second machine.The motors that come with the workbee are 175oz steppers, in my eyes a bit lite for a 4x4 machine.

https://www.ebay.ca/itm/4Axis-4-5Nm-...72.m2749.l2649

Any way I herd the bob board is not the best to use, wondering if there is a better solution I can use that doesn't cost more than the drivers and motors, I do have mach3 but haven't used it in years. and heard that a bit long in the tooth. acorn is way out of my price range. Any ideas?

Probably change the lead screws too if I can get some at a half decent price, the ones that come with it are 8mm, they should bee good for a smaller machine or 3d printer, the whipping will be bad I bet.