I'm having issues getting these faults to reset-
212 Magazine Drum Malfunction
302 ATC Arm Driver Malf.
304 ATC Controller Low Battery
305 Magazine Controller Low Battery
I have changed the batteries, but I can't figure out how to get the faults to reset.
"Reset" "MF1" and "MF2" clears it while your pressing it, but of course it comes right back.
Is there a reset for PLC faults or is this a CNC thing? I don't know where to even look to reset faults for the PLC.
I'm kinda concerned the params might be gone out of the drives, but I didn't shut it off in the hope that keeping power on would keep them from getting blown away.
Thoughts?
Thanks!