[dmoglianesi]

Please could you help me. I’ve to put in parallel two line of engines. Examplíe: x with z and y with a. Which is the command that I’ve to applaid?
Thanks a lot. Dalmazio.

[TomKerekes]

Hi Dalmazio,

I don't understand what you are asking. Possibly Master/Slave configuration?

[dmoglianesi]

[QUOTE = TomKerekes; 2341958] Ciao Dalmazio,

non capisco cosa stai chiedendo. Possibile configurazione Master / Slave ? [/ QUOTE]
dear tom, yes, x master z slave, y master a slave thank

[dmoglianesi]

dear tom, yes, x master z slave, y master a slave thank

[TomKerekes]

Hi Dalmazio,

I'm not sure whether you still have a question.

It would be better to reference KFLOP Axis Channels. ie.

X = Master KFLOP Axis #0, Slave KFLOP Axis #2
Y = Master KFLOP Axis #1, Slave KFLOP Axis #3

[dmoglianesi]

thanks tom, should I write these commands in the consol?

[TomKerekes]

Hi Dalmazio,

No you should configure the KFLOP Axes appropriately in the configuration screen as described in the Link I provided. Configure the each Slave axes to follow the appropriate Master.

Then configure the XY Coordinate System with:
DefineCoordSystem(0,1,-1,-1); // define X as Axis #0 and Y as Axis #1