Keep your eye on it...pay attention to it...treat it nice and you'll get good parts. Neglect one of the three and it grabs a knife from the kitchen and starts chasing you around the house.
Keeping up with bird nests, insert changes, tool wear and checking part measurements is a full time job in itself.
Been a long day and needed to vent.
Results 1 to 3 of 3
-
12-17-2019, 06:13 AM #1
- Join Date
- Nov 2019
- Posts
- 87
It's a bipolar, red-headed, stepchild!
-
12-17-2019, 03:56 PM #2
Registered
- Join Date
- Nov 2007
- Posts
- 2151
Re: It's a bipolar, red-headed, stepchild!
Most people I know think cnc machines are easy to setup, run, program, maintain, operate and design models for. Depending on what you are doing it can be far from it. And many times the faster you want it done the more attention it requires. Or you end up with a wtf just happened and the dog runs out of the shop.
I Also want to vent about how much time I spend cleaning up my shop. I need an industrial Roomba
-
12-17-2019, 07:11 PM #3
- Join Date
- Nov 2019
- Posts
- 87
Re: It's a bipolar, red-headed, stepchild!
Luckily the mess is contained in the machine unlike my manual lathes.
But, yes, not just a make design, click button, make $$$.
Reply With QuoteSimilar Threads
-
X3 CNC Conversion- the new red-headed-step-child
By WOTDesigns in forum X3/SX3/G0619/G0463Replies: 137Last Post: 02-10-2015, 08:49 AM -
Parallel Bipolar vs Half-Coil Bipolar
By gera229 in forum Stepper Motors / DrivesReplies: 14Last Post: 02-06-2015, 06:13 PM -
SLOT IN ROUND HEADED BOLD
By NIRAV1OO7 in forum G-Code ProgramingReplies: 2Last Post: 05-28-2013, 02:33 PM -
New Tormach Headed North
By Mooser in forum Tormach Personal CNC MillReplies: 2Last Post: 02-03-2008, 12:25 AM -
Bipolar Parallel or Bipolar half winding?
By Oldmanandhistoy in forum CNC Machine Related ElectronicsReplies: 20Last Post: 07-14-2005, 02:56 PM
Tags for this Thread
Posting Permissions
