512,335 active members
3,004 visitors online
Register for free
Login
IndustryArena Forum > CAM Software > CamWorks > Plunge rough down to one pass?
Results 1 to 3 of 3
  1. #1
    Member
    Join Date
    May 2019
    Posts
    27

    Angry Plunge rough down to one pass?

    Is there anyway to get this down to one pass? The cutter is 1" and even when I shrink the flat width to .3" I get two columns. I just want one path right down the middle. I don't feel this should be that complicated but I can't figure it out.

    I have tried several different combination of contain and avoid area. I am using a face feature since a boss feature doesn't have a plunge rough option.
    Attached Thumbnails Attached Thumbnails 4.jpg   3.jpg  

  2. #2
    Member
    Join Date
    May 2019
    Posts
    27
    Does any one know how to do this?

  3. #3
    Registered
    Join Date
    Jan 2014
    Posts
    25

    Re: Plunge rough down to one pass?

    Can you post a screen shot of what your trying to do

  4. #4
    Member
    Join Date
    May 2019
    Posts
    27
    I am trying to remove this boss with plunge rough, with one pass down the middle. I can only get it to where is goes down one edge and back up the other, two passes.
    Attached Thumbnails Attached Thumbnails Capture.jpg  

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •