Originally Posted by
woodcrafter10
I am having a problem where the UC100 is not being recognized, does not show up in the Device Manager under USB ports, if I disconnect it from the breakout board, which by the way I have been using for 2 years or longer, and then unplug the USB cable from it, it will then boot and connect to the PC.
My breakout board uses two 5 volt supplies, to keep everything isolated. Now I am not so sure that the I/O on the UC100 side should have a different power source than the UC100, i.e. from the PC rather than a USB charger plugged into the power strip.
Win 7 64 Bit, been running for 2 years or longer.
xylotek stepper controller, 3 axis A axis slaved to X Mach 3
Any thoughts on why the UC100 is not being recognized by the PC all of a sudden? Thanks in advance