If anyone could give me some places to look. I have no axis movement. Controller did work at one time, but computer was upgraded and now this. I have not messed with it for some time now so am very green.
-Mach3 and ESS are communicating
-5V exists between the EN and 5V on the C11
-1V on ports 2,3,4,5,6,7
-5V on ports COM*
-Stepper drivers are powered and look good to go
-Ports are enabled in Mach3
-No port lights on diagnostic screen
-I have no stepper movement and no status LED's are lit
-My C11 is rev 9.8