Hi guys, this may be a long shot, but here goes...... I am using the default mpan113x post that came with Mastercam V8. I would like to output a fixture offset # and some M codes when posting. I just recently saved an old Anilam 3300mk bed mill from the scrap heap and would like the be able to program on Mastercam instead of the conversational programing that's on the machine. I am not familiar with Anilam at all. All my experience has been with Fanuc and Mitsubishi. I think the mpan113x post is usable but outputting a fixture offset # or an M0 or M1 would be great. any help would be greatly appreciated thanks.