512,997 active members
3,029 visitors online
Register for free
Login
IndustryArena Forum > CAM Software > Mastercam > Post Processors for MC > Mastercam V8 post for Anilam 3300mk
Results 1 to 2 of 2
  1. #1

    Join Date
    Nov 2019
    Posts
    2

    Mastercam V8 post for Anilam 3300mk

    Hi guys, this may be a long shot, but here goes...... I am using the default mpan113x post that came with Mastercam V8. I would like to output a fixture offset # and some M codes when posting. I just recently saved an old Anilam 3300mk bed mill from the scrap heap and would like the be able to program on Mastercam instead of the conversational programing that's on the machine. I am not familiar with Anilam at all. All my experience has been with Fanuc and Mitsubishi. I think the mpan113x post is usable but outputting a fixture offset # or an M0 or M1 would be great. any help would be greatly appreciated thanks.

  2. #2

    Join Date
    Nov 2019
    Posts
    2

    Re: Mastercam V8 post for Anilam 3300mk

    I have been editing the post myself, and so far so good. The only problem I am having is that I want to post the following:

    Offset Fixture#0 at the end of the program and Offset Fixture#1 at the start of the program.
    The post ignores # signs so it just spits out Offset Fixture. I have a Bed mill that homes so I don't think I need to call up tool 0 before every Tool change. Instead I would like to post Z 6.00 since Z0 is always the top of the part while in Fixture Offset #1. 6 inches should be enough room to manually remove the tool. (Mill has about 16 inches of Z travel.

    Thanks again.

Similar Threads

  1. Anilam 3300MK
    By Dave Rothermel in forum Machine Problems, Solutions , Wireless DNC, serial port
    Replies: 0
    Last Post: 05-07-2012, 11:06 PM
  2. Anilam 3300MK
    By Buried in forum Machine Problems, Solutions , Wireless DNC, serial port
    Replies: 14
    Last Post: 05-02-2012, 05:36 PM
  3. Replies: 0
    Last Post: 12-27-2011, 07:14 PM
  4. Need post processor for Anilam 3300MK controller
    By kmgcmk in forum News Announcements
    Replies: 0
    Last Post: 12-07-2011, 05:46 PM
  5. Anilam 3300mk
    By klingnic in forum General CNC (Mill / Lathe) Control Software (NC)
    Replies: 6
    Last Post: 04-18-2011, 02:42 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •