[repauli1]

Vintage 1998 HAAS
When my tool holder grabs a tool and the spindle starts, there is a delay when set at any speeds above 2000 rpm, if I am doing an aggressive adaptive clearing I have to FEED HOLD right above work and wait about 5 sec for vfd to ramp up, if I dont it plows in, at low speed and then eventually alarms out shutting down. Anyone know why it would delay before going full rpm? I noticed this after losing my original HAAS .post file.

[machinehop5]

check Parameter 209 bit 31 (SPNDLE NOWAIT)
https://www.haascnc.com/content/dam/...ual---2002.pdf
PAGE 278-279

[repauli1]

Thanks for the response, I cannot find that parameter even though its in my book, I am on the 209 par page also???

[machinehop5]

YW.

Did you use the? ............."The left and right cursor arrows are used to select the function being changed. All values
are 0 or 1 only."

DJ

[repauli1]

I know how to change it, just cannot find that parameter on my list under 209

[repauli1]

I know how to change it, just cannot find that parameter on my list under 209

A work around I put a G4 P2500 right after the G54 move (Dwell 2500ms)