[Stevenb856]

Having issues resetting up the laser to work correctly after a windows 10 update last year. Manufacture is less then helpful. (no surprise there)
1. 30watt chinese fiber laser with F-Theta F-330mm 1064nm len
2. Board Model: LMCFIBER JXT-M40015 REV 20120321
3. Ezcad2 software
4. windows 10 32bit as I found out laser will not support the 64bit os.
5. Will check all the solider joints as i'm still getting DOG message even with correct driver installed. (All of inside connectors are tight and joints are good in the welds)

Other then that i have had this 6k unit on my desk for a year without being able to use it.
I have the ability to remote someone in if there willing to give me a hand with this.

Thank you,

Steven