531,873 active members*
2,815 visitors online*
Register for free
Login
Results 1 to 6 of 6
  1. #1
    Member
    Join Date
    Jan 2020
    Posts
    1

    30watt fiber laser Chinese and Ezcad2

    Having issues resetting up the laser to work correctly after a windows 10 update last year. Manufacture is less then helpful. (no surprise there)
    1. 30watt chinese fiber laser with F-Theta F-330mm 1064nm len
    2. Board Model: LMCFIBER JXT-M40015 REV 20120321
    3. Ezcad2 software
    4. windows 10 32bit as I found out laser will not support the 64bit os.
    5. Will check all the solider joints as i'm still getting DOG message even with correct driver installed. (All of inside connectors are tight and joints are good in the welds)

    Other then that i have had this 6k unit on my desk for a year without being able to use it.
    I have the ability to remote someone in if there willing to give me a hand with this.

    Thank you,

    Steven
    Last edited by Stevenb856; 01-31-2020 at 03:23 PM. Reason: updated information

  2. #2
    Registered
    Join Date
    Aug 2009
    Posts
    248

    Re: 30watt fiber laser Chinese and Ezcad2

    i'm using windows 10 x64 with EzCad2 2.14.11 , is it the drivers missing? i have the LMC4 Fiber + 60w raycus, and 110mm 185mm lense so can't help you with the cal much, i posted my settings just now on the other thread, but prob not much help.

  3. #3

    Re: 30watt fiber laser Chinese and Ezcad2

    i am having same issue fiber laser windows 10 64 bit say demo mode

  4. #4
    Registered
    Join Date
    Aug 2009
    Posts
    248

    Re: 30watt fiber laser Chinese and Ezcad2

    demo mode means its not detecting the usb device, which likely means the drivers aren't installed, or 32 bit drivers on a 64 bit os.

  5. #5
    Member
    Join Date
    Aug 2020
    Posts
    20

    Re: 30watt fiber laser Chinese and Ezcad2

    According to the model number you mentioned, it seems like a copy controller. You can compare the original one with the copy one at https://www.chineselaser.com/

  6. #6
    Member
    Join Date
    Nov 2020
    Posts
    1

    Re: 30watt fiber laser Chinese and Ezcad2

    i bought a BJJCZ marking board FBL1-B-LV4 , and i am stuck in demo mode. I tried windows 7 with no luck . Any advise or driver? Please help.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •