[the-niho]

I have an issue with the machine, the error was displayed once or twice but now when i startup the machine it goes to reference parameters menu and it does not allow me to start the drivers without displaying an error.I also dont hear the air valve opening and hydraulic starting as it usually does.

Error shows in red square after it pops out of controller and it requieres a reboot.

originally machine shows it in German and it goes :

N76 8CA0 Referenzsignal oder strichzahl S fehlerhaft ( google translate- Reference signal or line number S faulty)
Module: Q:/commonTNC/sources/regel/dsperror.cpp
Line:328
Process: REGEL
Thread: DSPCLIENT
Errno : 2
Press the END key if you want to reboot the controll

Can anybody clear this for me ,this is the only machining center in my shop and the main machine ,and as it usually goes it makes problems when you are in a tight spot!! :drowning:

HELP

Thanx

[arenamember]

iTNC530 Programming Station for Windows 7

Hello

Thank you for entering in my post

I am posting here since I could not find a link to open a new thread

I do have on my old laptop with Windows 7 an iTNC530 Programming Station, which works beautifully.
I want to have the same software on my new Desktop tower PC which also have windows 7.
I did try to download both of these 2 programs in this link http://cid329p1338.hd45.hosting.punkt.de/?id=465 but it did work, I did try to deactivate my antivirus and turn off my firewalls before to do the download but no success
Any suggestion according this matter will be very appreciative
Thank you in advance for your support

[ravinders03]

I have a DMG dmc835v and i got the same alarm today. How did you fix it?

I have an issue with the machine, the error was displayed once or twice but now when i startup the machine it goes to reference parameters menu and it does not allow me to start the drivers without displaying an error.I also dont hear the air valve opening and hydraulic starting as it usually does.

Error shows in red square after it pops out of controller and it requieres a reboot.

originally machine shows it in German and it goes :

N76 8CA0 Referenzsignal oder strichzahl S fehlerhaft ( google translate- Reference signal or line number S faulty)
Module: Q:/commonTNC/sources/regel/dsperror.cpp
Line:328
Process: REGEL
Thread: DSPCLIENT
Errno : 2
Press the END key if you want to reboot the controll

Can anybody clear this for me ,this is the only machining center in my shop and the main machine ,and as it usually goes it makes problems when you are in a tight spot!! :drowning:

HELP

Thanx

[ersatishmishra]

same error come in my machine kindly suggest the remedies for the same .i m stuck up.
how you reolved the issue pls update me

thanks

[ersatishmishra]

same error occured in my machine pls reply probable cause of above issue.we will check accordingly
your reply is valuable for me