[pastaman]

I'm selling my PM-932 CNC mill so I can move up to a industrial level machine. If you are looking for a turn key CNC mill loaded with options this is the one for you.

Precision Mathews PM-932 milling machine purchased new

Column stiffening mods

WJ200 Hitachi VFD with 2HP Marathon Black Max Inverter Duty Motor

Two speed belt drive spindle conversion with angular contact bearings (8500 RPM max speed)

PMDX-126 breakout board, PMDX-107 spindle control board, Warp9 ethernet smooth stepper

Nema 34 stepper motor with dual shafts on X and Y axis, 1600 oz-in holding torque

Nema 42 stepper motor with single shaft on Z axis, 4200 oz-in holding torque

DQ860MA/7.8A stepper drivers on X and Y axis

DQ2272/8.0A peak current, 7.0A rated current stepper driver/power supply on Z axis

350W, 60VDC, 5.9A power supply for X and Y axis

Rollaway with AC power system components located in bottom drawer

Licensed copy of Mach3, CamBam and D2NC

Laptop computer running Windows7 64 bit, monitor, keyboard and mouse

Braking resistor to allow for power tapping

1605 ball screws and double ball nuts on X and Y axis

2005 ball screw and double ball nut on Z axis

Z axis ball nut carrier mod to minimize backlash

Extended X and Y axis travel

One shot lube system

Full enclosure with overhead lighting

Flood coolant system including reservoir, pump, spare pump, filter and oil skimmer

2010 screen set with fixed tool setting plate

Ultron Snap Change tool changer and tool holders only. Cutters, drill bits and and other cutting or measuring devices are not included

Auxiliary high speed spindle (24000 rpm) with PID controller

Z axis tool setter

X, Y, and Z axis limit and home switches

All equipment manuals, configuration instructions, and notes included

Manual mill components removed for the CNC conversion included

[Clbalso]

How much are you asking and where are you located?

[pastaman]

The mill has been sold.