[Conundrum68]

2010 TM-2.
It has the Ethernet option and I have set it up to successfully interact with a NAS share.
I also set up its own internal "ACCESS TO CNC SHARE" as "FULL" and can see it from my computer as (\\hhas-tm2).
From my computer, I can send files to it, edit them, rename them, etc (full access is turned on)

HOWEVER

I cannot see where the hell the files actually ARE on the mill!

I have:
"HARD DRIVE TAB ENABLED" set to ON but cannot see the HARD DRIVE tab.

I have:
"ENABLE HARD DRIVE" set to 1.


I looked as best as I could inside the control cabinet but could not find a hard drive (obviously it could be hidden).
The files are getting stored SOMEWHERE (presumably on a hard drive...).

I have searched through the forums and all over the Googles, and cannot find info on this.
Anyone have any ideas?
Thanks.

[machinehop5]

does this help ya...see something about "Remote Net Share Enabled"
https://staging-diy.haascnc.com/net-share-settings

[Conundrum68]

Ok figured it out, thanks.
Although I had SHOW HARD DRIVE TAB enabled, I actually did NOT have HARD DRIVE ENABLED set to "1".
That did the trick.