585,735 active members*
4,797 visitors online*
Register for free
Login

Thread: I'm stuck again, wiring

Results 1 to 2 of 2
  1. 02-15-2020, 03:12 AM #1
    rmachinist
    rmachinist is offline Registered
    Join Date
    Jan 2012
    Posts
    163

    I'm stuck again, wiring

    Hi,

    My driver has Pul+,Pul-,Dir+,Dir-,Ena+,Ena-, i'm using C11G board, my concern is the wiring diagram doesn't use Ena+,Ena- there diagram uses c10 board for example. If It make any difference I'm running closed loop steppers https://www.cnc4pc.com/pub/media/pro...es/WS_89_1.pdf
    Reply With Quote Reply With Quote
  2. 02-15-2020, 05:15 PM #2
    Fastest1
    Fastest1 is offline Gold Member
    Join Date
    Nov 2009
    Posts
    4415

    Re: I'm stuck again, wiring

    From everything I read the enable pins dont have to be used. If you do use them, there is an extra layer of protection. How to wire the enable pin on a stepper drive?
    A lazy man does it twice.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. 8 wiring encoder wiring to step2linear
    By taoufikbenzart in forum Viper Servo drives
    Replies: 0
    Last Post: 11-24-2019, 08:41 PM
  2. International wiring codes for 1- , 3-phase, AC, DC and control wiring
    By dmannock in forum Chinese Machines
    Replies: 19
    Last Post: 07-30-2015, 01:44 AM
  3. wiring check please. parallel wiring to maximum current to servo motors
    By Novett in forum CNC Machine Related Electronics
    Replies: 3
    Last Post: 10-11-2014, 07:54 PM
  4. Another sPID, G540, and Mach wiring question for the wiring challenged..
    By adam_m in forum DIY CNC Router Table Machines
    Replies: 17
    Last Post: 01-02-2014, 01:29 AM
  5. X value stuck at 0.001
    By OCNC in forum NCPlot G-Code editor / backplotter
    Replies: 3
    Last Post: 02-16-2011, 12:42 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules