Hello all,

I try to configure a Delta ASDA-AB servo drive + delta 400W motor that I salvaged from a machine.
I want the drive/motor combo to work with enable/step/dir signals and I absolutely got lost
in the jungle of all that parameters and options.
I liked to attached the manual of that drive, so anybody trying to help doesn't need to search for it.
Unfortunately the file was to large to attach.

Initially the drive and motor did nothing, so I did a reset to factory defaults of all parameters.
Then I tried to figure out what parameters do I need.

What I got working so far is:
on CN1 I connected buttons for enable jog-forward/reverse
I put the drive in PT (Pulse Train) mode

It kind of works, but not as expected.

1.
If I enable the drive (SON), I expect the motor to be stiff. Meaning intending to spin the shaft should
put the force of the drive against the intent and the drive should try to hold exact position.
That happens, kind of, but it has about 5 degrees of play in either direction before the drive kicks in
to hold the shaft.

2.
Jog speed is set to something.
If I SON the drive and press one of the jog buttons, sometimes he starts to spin, sometimes the shaft
needs a nudge to start spinning. If the shaft is spinning, he holds exact programmed velocity and has
enough torque (I cannot stop him by hand).

I read about all parameters listed in the manual, but got overwhelmed, and actually I'm not sure if
the drive has a problem or my parameter combinations.

Anyone can give me some hints how to proceed with that.

Many thanks
Ju