[taths]

I have this controller Usb 4 Axis Mach3 100 Khz Usb, and Huanyang VFD, I tried everything, but it didn't start some help ?

[mactec54]

I have this controller Usb 4 Axis Mach3 100 Khz Usb, and Huanyang VFD, I tried everything, but it didn't start some help ?

Do you have a wiring diagram you can post of the Breakout Board, it does not appear to have a Relay or PWM 0-10v analog output

[taths]

Thanks for the answer, photo with connectors,sorry for my english, i use translation.

[mactec54]

Thanks for the answer, photo with connectors,sorry for my english, i use translation.

Check that the ACM and DCM are the same if not they can not be connected / wired like that ACM is Analog Common DCM is DC Common

FWD and output 2 I don't think will work for your VFD Drive, what does output 2 do, if this has voltage then it will not work it would have to turn a Relay On / Off to be used if it has a voltage FWD and DCM is just a switch with no voltage to make the VFD Drive turn On / Off