[fsa]

The pictures and information are in the turret manual too if you look.

Both proximity sensors works ok but indexing Solenoid not de energizing..after energized...I check voltage on indexing Solenoid after tool change cycle activate... voltage is changing from 0 to 17 but not zero till I press the reset button...
I hope this can help you to reach the fault

[fsa]

The pictures and information are in the turret manual too if you look.

Both proximity sensors works ok but indexing Solenoid not de energizing..after energized...I check voltage on indexing Solenoid after tool change cycle activate... voltage is changing from 0 to 17 but not zero till I press the reset button...
I hope this can help you to reach the fault

[fsa]

ok jono 1961 so your advise that i change locking control switch and reset the turret timing..but how to reset the turret timing can you guide me please.

Both proximity sensors works ok but indexing Solenoid not de energizing..after energized...I check voltage on indexing Solenoid after tool change cycle activate... voltage is changing from 0 to 17 but not zero till I press the reset button...
I hope this can help you to reach the fault

[fsa]

Along the top from 4 to 8 are the relays for your turret check they are working. 6 is your shot bolt had this last week changed 5 and 6 started working however you have never said it works in reverse before
Good luck
.as I said ages ago have you checked you are getting 24v to the turret

Sir what is the purpose of shot bolt..

- - - Updated - - -

ok jono 1961 so your advise that i change locking control switch and reset the turret timing..but how to reset the turret timing can you guide me please.

Both proximity sensors works ok but indexing Solenoid not de energizing..after energized...I check voltage on indexing Solenoid after tool change cycle activate... voltage is changing from 0 to 17 but not zero till I press the reset button...
I hope this can help you to reach the fault

[fsa]

can you guide me how* to check shot bolt to confirm that its working or not...because yesterday i*remove*shot bolt rely and run turret the problem*is same as relay connected ..it seem*there is no difference either shot bolt rely connect*or not ..any idea????e...

[fsa]

where is shot bolt in this drawing can some one guide me

[RDTS]

Were can I get boring bar holders for the Diplomatic turret BSV-N-120

[mbservice]

Ebay

Were can I get boring bar holders for the Diplomatic turret BSV-N-120

[RDTS]

Ebay

I wish. No joy there. I contacted toolholdershop out of Canada and may have them make me a few.

[mbservice]

Vdi 20 ?

[RDTS]

Vdi 20 ?

My Google Foo didn't pull anything up for Vdi 20.

Won't let me upload a pic?

[mbservice]

I've sent you my email

[RDTS]

I've sent you my email

Never got it?

[mbservice]

Sent you a private message