G76 issue
I am threading an 8-acme inside thread, I set the Q to 14, however the cut angle is much greater than that. probably closer to 20 or even as much as 25 degrees. when I cut a 60 degree thread and set the compound angle Q to 30 it works fine. has anyone else had this issue and may have a fix for it?
this is the code:
G76 P0.125 Z-3.0 I0.100 J0.008 K0.170 Q14 R1.5
I plan on trying a Q7, but even if that works I would still like to understand the problem.
thanks for your help.
Ray,
Life is a choice, death is choice poorly made.