Hello.
I wounder if somebody can help me to get this macro woorking.
I try to make a program to measure all the tools on the tool presetter. I made this macro that i attached the program at the end of the post. This now works with M110. The program and measuring runs just fine, but the values from the presetter does not appear in the tool offset table.
When i use the presetter i manual mode it works as i should.
I hope some of you can help me.
#1 =#4014
G58
G28 U0
G0 T#20
M77
G0 Z495
G0 X180
G36 U-12
G0 U12
G0 Z509
G0 X155
G37 W-11
G0 W11
G28U0
M76
M99