[NovaSp]

Hello ,

Machine is a VM 40II with Seicos M 16 III control. It has a 1012 Sams Alarm, controlled axis error. Can't clear it . All the boards have appropriate lights. Anyone have this problem before. Any help would be much appreciated on solving this issue.
Thanks, Kevin

[shas595]

Kevin,

check Parameter 1014 against your sheets and let me know. That alarm states "The Number of system axes are smallr than the number stored in PRM1014 - Control Axes"

John

[NovaSp]

John,

Thanks for reply. Parameter 1014 on sheet and mill is on 4. I switched to 0 then back to 4 in thinking to get the axes re read. Had to re enter it via rs232. All green lights on boards. Checked voltage on SPHC and all is correct.
Thanks, Kevin

[shas595]

Kevin,

Then it's likely either the SAMS or SASS board. Any other indications of the problem? Anything else weird happening?


Sent from my iPhone using Tapatalk

[shas595]

Kevin,

Then it's likely either the SAMS or SASS board. Any other indications of the problem? Anything else weird happening?


Sent from my iPhone using Tapatalk

[Demech]

I HAVE A VM40 /2 DISPLAYING 1106 PLUS 102 ALARM SAYS FAULT ON SPHC BOARD MACHINE WONT RUN . CAN ANY ONE OFFER AD VICE AS TO WHAT MAY HAVE OCCURED.
WE DID HAVE A BATERY CODE AS WELL, BUT HAVE REPLACED THE BATTERY WITHA LITHIUM 3.6V AND THE BATTERY CODE HAS GONE
WOULD APPRECIATE ANY HELP, PLEASE!
ADRIAN [email protected]