[Mudu3000]

Hi l am a newbie to the laser world having owned one for just over 4 weeks. I am trying to figure out how I can, engrave at different power, speed and finally cut a material design in a single run?

By this I mean using corel draw to setup the sequence of activities and executing as one job.

Example:
1. Engrave a star at 20% power , speed 100 mm/s
2. Engrave a star at 50% power, speed 150 mm/s
3. Engrave a star at 75% power, speed 200 mm/s
4. Finally cut out rectangle, power 30%, speed 10 mm/s

I could be wrong but my research indicates that I cant do the above in one run! I have to manually do each step.

Can someone help clarify this please?

[fixtureman1]

You have to use colors and set each one to what power you want and scan or cut

[Mudu3000]

So it is possible
Are you aware of any videos or tutorials that will help me get my head round this?

[fixtureman1]

You just have to assign a color to each thing and adjust your settings to do what you want.

[Mudu3000]

You just have to assign a color to each thing and adjust your settings to do what you want.

I have figurer out how to run two tasks, engrave and cut, but how do you set the power for each task from the software? My laser machine has a digital display that I have to adjust for the power in %.

[fixtureman1]

What controller do you have

[Mudu3000]

What controller do you have

Controller: Nano M2;

[Mudu3000]

Hi folks, wondering how I can control thr power of my laser machine from the coral laser software package. See image attached, as you can see the feature seems to be disabled.