It has been about 6 years since I was on this site. My machine has just been taking up space for several years. I just decided to clean the dust off. I wanted to make it bigger so I rebuilt it. I am using a RnR usb motion board. I have watched some of the videos and downloaded the xml file. I am at a loss as to how to set up the motor outputs in Mach3 (Port # and address, pins, etc.) I could use a little help from you experts. I will be using it as a router. I have installed a 1500watt spindle. I have it running off the front panel. Any help would be appreciate any help you can give.
Thread: Rebuild
Results 1 to 3 of 3
-
04-14-2020, 06:36 PM #1
Registered
- Join Date
- Apr 2011
- Posts
- 8
Rebuild
-
04-14-2020, 08:43 PM #2
Banned
- Join Date
- Aug 2009
- Posts
- 1570
Re: Rebuild
...welcome back. Post some photos maybe of axis motor spec's and wiring would help.
-
04-14-2020, 09:29 PM #3
Registered
- Join Date
- Apr 2011
- Posts
- 8
Re: Rebuild
Never mind guys, I think the xml file is fine. I am just not getting communication from Mach3,
Reply With QuoteSimilar Threads
-
My first CNC (rebuild of an old CNC)
By Tooms in forum DIY CNC Router Table MachinesReplies: 9Last Post: 05-12-2014, 08:51 PM -
X2 rebuild soon to be CNC'd
By 1HobbyMachinist in forum Benchtop MachinesReplies: 5Last Post: 03-03-2012, 05:43 AM -
PC 690 Rebuild
By jharvey407 in forum DIY CNC Router Table MachinesReplies: 3Last Post: 10-28-2011, 01:30 AM -
rebuild help
By houdini in forum I.C. EnginesReplies: 6Last Post: 04-14-2008, 02:16 PM -
rebuild
By corrie in forum CNC Wood Router Project LogReplies: 5Last Post: 03-20-2008, 10:29 PM
Tags for this Thread
Posting Permissions
