[geast1967]

Hello everyone.
I have an old mill with a Syntec 900ME controller and i need to alter some machine parameters.
The problem is that when i want to change anything it ask for a password, which i don't know.
Is there any default password or any other way to reset the password ?
I read somewhere for a 520 password but it does not work on my machine.
Any help would be appreciated.

[jaideepshinh]

Hi,

You could contact Syntec directly for this (I could DM you their contact details if you would like)

I have visited them in Taiwan- they're a good and helpful company. I have 5 machines with their controllers in my factory at the moment.

Best regards

Jaideep

[geast1967]

Yes please if you could send me the contact i would be greatfull..

[ounsiam]

Hi Jaideep,
I need password for Syntec 6MB as well,
could you please send me the contact also.
Thanks.

[Buildit247]

Hi Jaideep,
I need password for Syntec 6MB as well,
could you please send me the contact also.
Thanks.

Did you ever figure out password problem. I am in the same boat but thinking on reloading but I would much rather hack it

Brian

[Buildit247]

Yes please if you could send me the contact i would be greatfull..

Did you ever figure it out I am in same boat

[jaideepshinh]

Dear Brian,

My machines password is 520 from what i recollect. If you enable your direct messages I will send you the contact details (I do not wish to post these on an open forum as the personnel at Syntec would get spammed otherwise)

Best regards
Jaideep

[ZanderGahel]

tengo el mismo problema con mi Syntec 20TA se descargaron las baterias y se borraron las referencias, quisiera saber si hay algun procedimiento especial ya que me pide una contraseña intente con las 520 y 521 pero no funcionan, gracias.

[geast1967]

The default password is 520, if it is not then you will need to consult to your machine maker/seller.

[ZanderGahel]

geast1967 tendras algun procedimiento para volver a guardar las referencias, mis servos tienen encoder absolutos.

[geast1967]

You better contact direct to Syntec to that email,[email protected].
Regards.

[starkvogel]

Hello everyone.
I have an old mill with a Syntec 900ME controller and i need to alter some machine parameters.
The problem is that when i want to change anything it ask for a password, which i don't know.
Is there any default password or any other way to reset the password ?
I read somewhere for a 520 password but it does not work on my machine.
Any help would be appreciated.

Just looking forum about Syntec and it seems that your system configuration is same as mine.
4 axis with 2 CF Card Installed (DOS).
I wonder why suddenly it asking for password, and I can't find the password anywhere.
The bad news is I haven't backup the original CF Card that located inside.
It asking for password for Check No. 3318
Can you help me with my issue?

[geast1967]

You have to contact the machine builder, for the password.

[Andis]

Try 521

[magzi]

Dear geast1967,

Does your machine have a CF card inside the controller? (on the advantech's PCA6773 motherboard?)

Best regards
Michael