[thardy]

On the Fanuc OTC you can turn the in position check off in the parameters under line 20 bit 5.
Where do you turn it off on a Fanuc OTa?
Diagnostic # is 0700 bit 3 but it won't let you turn it off under the diagnostic.
Thanks for any help.
Thomas Hardy

[L. Sakthivel]

Inposition check cancel parameter not available in 0TA manual. But you can adjust the values of inposition as required for you.
Inposition width Parameter 70 & 71 ( X & Z )
Limit Value of position deviation in stop condition Parametre 74 & 75
Limit Value of position deviation in movement condition Parametre 78 & 78

The above parameters Setting value is 0 to 32767 Detect unit

[derwaysh khan]

dear friends i have a tornado 200 CNC with fanuc otc control, i am facing some alarms when i start the machine then i found these alarms on the screen, 409,414 and 424 which are not removed by pressing reset button. then i saw in diagnostic parameter
720=01000000
721=01000000
727=00000000
Is there any boby to tell me the solution of these faults.