PathPilot Issue - Lost Tool Table
Hey Folks;
I just upgraded my pathpilot from 1.9 to 2.1.5 and for some reason, my tool table keeps getting reset to 0. I used the Tormach procedure for upgrading and backed up/restored my system and all seemed well. However, when I cycle the system (shut down / restart) my tool table goes to zero. I can again restore and it is back. Also, I tried to manually repopulate the table (offsets) but it does the same thing. Cycle the system and all is again, lost.
Has anyone see this before. Any ideas.
I did ask the same question over on the linux pathpilot forum but have not received any guidance.
I can get by by restoring the system every startup but what a PITA.
Once again!!!
Help Please.
Bill
Oh yeah, where did the pathpilot area on system controllers disappear to? The linux thread is there by no PathPilot!!!
- - - Updated - - -
Sorry Guys.
My system is a novakon torus pro servo system.
Old but reliable.
B
billyjack
Helicopter def. = Bunch of spare parts flying in close formation! USAF 1974 ;>)