Hi. Our makerspace has a new 1390N 130 watt cutter. We need to keep the mA draw at 30 mA or less to prevent damage to the tube. Problem is, we have a lot of uneducated members that even if you tell them "how", they don't always follow the rules, so we're trying to hard set the machine to protect it from improper use (as much as possible).
It seems as though with RDWorks, it can limit itself based in internal settings of the configuration, but Light Burn software has to be at 60% or less to keep from going over 30mA.
We've discovered a potential solution here: https://www.instructables.com/id/How...ade-CO2-Laser/
I'm wondering if there are any other 1390N or 1390 (or GWeike in general) that have attempted anything similar, or have any other suggestions for me.
Kind regards,
Jeff