[minisoren]

Anyone know how to solve error code ERR 0 23, I 05
Philips 432

[viorel23cnc]

I05 is normal until you power up the hydraulics , O 23 is an operator error that appears when you type something wrong at the controller. I am amazed that no one sims to replay anymore on this forum.

[minisoren]

Hi Thanks for the replay
I manages to get rid of the O 23 error, the backup battery were dead so I had to enter all the constants again.
I still have the I05 error and the hydraulic will not start only if I keep my finger on the button.
I have tried to activate the switch for the axis end stop to see if switches for the axis is jammed, but I still have the error.

Sorry for my late replay I am new in the forum.
I have open a new thread with a picture I didn't know how to add a picture in this one.

[viorel23cnc]

If the limit switches are clear than you should know that there is a technique for powering one the hydraulics. Firs if the machine has sat over night , press the hydraulic switch for a couple of seconds to build up pressure. Than the procedure it self is to keep the hydraulic button pressed for a second ore two with one hand than immediately after depressing it press the CLEAR button. Normally the OPENLOOP will be gone and the machine will work.

[minisoren]

I tried what you recommended but hydraulic stop when I release the button, and I have the error that is showed on the picture.
When I tri to start, all the safety gates are closed and no emergency buttons are activated.

[viorel23cnc]

I tried what you recommended but hydraulic stop when I release the button, and I have the error that is showed on the picture.
When I tri to start, all the safety gates are closed and no emergency buttons are activated.

Are your constants ok? Is the table all the way down?

[minisoren]

Constants seems ok, i am able to start and run all 3 axis to reference point.
Next step spindel RPM and tool changes check:

If i try to start spindel i get alarm E93. i use S600M3.
If i try to changes the tool, the tool magazine just keep spinding ( tool magazin is emty) but it should do the opreation anyway? T6M6

[viorel23cnc]

The Maho mh 600 e has a gearbox for speeds. So you ca only imput fix speeds like S 500 , S630 .

[wardygb]

Hi do you still have this problem?
There is normally a reference switch on the tool magazine, if this is faulty the magazine cannot reference and position properly
A t b