Hi Everyone,
I'll start by giving a little background on my CNC plasma table. I had the table built by a guy out of London Ontario. He had my plasma machine and my money and I was dealing with him back and forth for over 2 years with nothing really to show for it. Without getting into too much detail, the guy wasn't very honest he and I had to go there and basically take my equipment including what he had built so far on the table. The table was incomplete and I have gotten it to the point where everything works except for the torch trigger hook up and my Proma THC. I have attempted to wire everything the best I can, but need some assistance as I can not get the torch trigger to fire when I am running a file.
Here is some info on the table and software I'm using:
- 4×8 table
- Longevity Forcecut 42i plasma cutter with straight torch
- XHC MK 3 Mach 3 Motion Card
- Mach 3 Software & Sheetcam Software
- Proma THC
I have attached some pictures in a pdf document (The file size for the pictures were too big so had to shrink them in a pdf so it would upload) to show how I have everything wired so far and to show my ports and pins. I'm not sure if the issue is with the wiring or the ports and pins or a mixture of both. If someone would be able to give me some help and a little guidance I would really appreciate it. I know I am very close and can't wait to get it all working properly. If you need any more info or pics let me know. Thanks again in advance.